9-12 TRANSMISSION
Tr ansmission and Shift Mechanism
•
Screw the joint [A] of the shift shaft lever [B] fully into the
transmission shift cable [C] end, and install the cable onto
the bracket [D].
•
Line up the punch mark [A] on the shift arm, projection
[B] on the transmission case and slit opening in the shift
shaft lever [C].
•
Tighten:
Shift Shaft Lever Nut [D]
Shift Shaft Lever Clamp B olt [E]
•
Hold the shift shaft lever [A] in the neutral position, and
then pull the outer cable [B] lightly forward to remove the
cable free play.
NOTE
○
If the cable cannot be adjusted, move the slit opening in
the shift shaft lever one notch to right side of the punch
mark on the shift arm.
•
Tighten:
Transmission Shift Cable Adjuster Nut [C]
Transmission Shift Cable Adjuster Nut [D]
•
Install the spring [A] back onto the shift shaft lever assem-
bly.
•
Check the shift lever position (see Shift Lever Position
Inspection).
Comments to this Manuals