California Air Tools 3010 Service Manual Page 310

  • Download
  • Add to my manuals
  • Print
  • Page
    / 368
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 309
16-12 ELECTRICAL SYSTEM
Battery
Electrolyte Filling
CAUTION
Do not remove the seal sheet sealing the filler ports
until just before use.
Be sure to use the dedicated electrolyte container
for correct electrolyte volume.
Check to see that there is no peeling, tears or holes in the
seal sheet on the top of the battery.
Place the battery on a level surface.
Remove the seal sheet [A].
When removing the sheet, check to hear an air-sucking
sound “Shoosh!” from filler ports [B].
NOTE
A battery whose seal sheet has any peeling, tears,
holes, or from which the air-sucking sound was not
heard requires a refreshing charge (initial charge).
Take the electrolyte container out of the vinyl bag.
Detach the seal cap [A] from the container.
NOTE
Do not discard the seal cap because it is used as the
battery plugs later.
Do not peel back or pierce the seals [B] on the c ontainer.
Place the electrolyte container upside down aligning the
six seals with the six battery filler ports.
Push the container down strongly enough to break the
seals. Now the electrolyte should start to flow into the
battery.
NOTE
Do not tilt the container as the electrolyte flow may be
interrupted.
Make sure air bubbles [A] are coming up from all six filler
ports.
Leave the container this way for 5 minutes or longer.
NOTE
If no air bubbles are coming up from a filler port, tap [B]
the bottom of the container two or three times. Never
remove the container from the battery.
CAUTION
Fill the e lectrolyte into the battery until the con-
tainer is completely emptied.
Page view 309
1 2 ... 305 306 307 308 309 310 311 312 313 314 315 ... 367 368

Comments to this Manuals

No comments