California Air Tools 3010 Service Manual download pdf (Page 313)

100

101

ELECTRICAL SYSTEM 16-15

Battery

Refreshing Charge

•

Remove the battery [A] (see B attery Removal).

•

Do refresh-charge by following method according to the

battery terminal voltage.

WARNING

This battery is sealed type. Never remove seal cap

[B] even at charging. Never add water. Charge with

current and time as stated below.

Terminal Vo ltage: 11.5 ∼ less than 12.6 V

Standard Charge

1.8 A × 5 ∼ 10 h (see following

chart)

Quick Charge

9.0 A × 1.0 h

CAUTION

If possible, do not quick charge. If the quick charge

is done due to unavoidable circumstances, do stan-

dard charge later on.

Terminal Voltage: less than 11.5 V

Charging Method:

1.8A×20h

NOTE

○

Increase the charging voltage to a maximum voltage of

25 V if the battery will not accept current initially. Charge

for no more than five minutes at the increased voltage

then check if the battery is drawing current.

If the battery will accept current, decrease the voltage

and charge by the standard charging method described

on the battery case.

If the battery will not accept current after 5 minutes, re-

place the battery.

Battery [A]

Battery Charger [B]

Standard Value [C]

1 2 ... 308 309 310 311 312 313 314 315 316 317 318 ... 367 368

Comments to this Manuals

No comments

California Air Tools 3010 Service Manual Page 313

Comments to this Manuals

Related products and manuals for Air compressors California Air Tools 3010