California Air Tools 3010 Service Manual Page 269

  • Download
  • Add to my manuals
  • Print
  • Page
    / 368
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 268
SUSPENSION 13-5
Struts and Rear Shock Absorbers
Apply grease to the upper and lower side on the following
parts, and install them.
Dust Seal [A]
Thrust Washer [B]
Face the projection on the thrust washer downward.
Install:
Holder [A]
Large Washer [B]
Small Washer [C]
Lock Nut [D]
Push down the holder, and tighten the locknut.
Torque - Strut Lock Nut: 49 N·m (5.0 kgf·m, 36 ft·lb)
Rear Shock Absorber Removal
Remove:
Rear Wheel (see Wheels/Tires chapter)
Remove:
Rear Shock Absorber Mounting Bolts and Nuts [A] (while
moving the frame up or down w ith a jack)
Rear Shock Absorber [B]
Rear Shock Absorber Installation
Install the rear wheel temporarily and ground it to load the
suspension.
Tighten:
Torque - Rear Shock Absorber Mounting Nuts: 59 N·m (6.0
kgf·m, 43 ft·lb)
Shock Absorber Inspection
Visually inspect the shock absorber for breaks or distor-
tion.
If the shock absorber is damaged in any way, replace it.
Check for oil leakage at the shock absorber damper unit.
If oil leakage is noted, the shock absorber should be re-
placed to renew the oil seal.
Visually inspect the rubber bushings in the upper and/or
lower mountings of the rear shock absorber.
If they are worn, cracked, hardened, or otherwise dam-
aged, replace them with new ones.
Page view 268
1 2 ... 264 265 266 267 268 269 270 271 272 273 274 ... 367 368

Comments to this Manuals

No comments