California Air Tools 3010 Service Manual Page 365

  • Download
  • Add to my manuals
  • Print
  • Page
    / 368
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 364
APPENDIX 17-7
Bolt and Nut Tightening
Tightness Inspection
Check the tightness of the bolts and nuts listed here. Also,
check to see that each cotter p in is in place and in good
condition.
NOTE
Check the engine fastener tightness when the engine is
cold (at room temperature).
If there are loose fasteners, first loosen by 1/2 turn, then
retorque them to the specified torque following the speci-
fied tightening sequence. Refer to the appropriate chap-
ter for torque specifications. If torque specifications are
not in the appropriate chapter, see the basic torque table
(see Torque and Locking Agent in the General Informa-
tion chapter).
If cotter pins are damaged, replace them with new ones.
Nut, Bolt, and Fasteners to be checked
Engine:
Engine Mounting Bolts
Exhaust Pipe Holder Nuts
Exhaust Pipe and Muffler Clamp Bolt
Muffler Mounting Bolts
Throttle Pedal Pivot Clip
Fuel Tank Holder Nuts
Transmission/Final Drive:
Axle Nuts and Cotter Pins
Drive Shaft Bracket Mounting Nuts
Transmission Shift C able Upper End Clip
Transmission Shift Lever Clamp Bolt
Differential Shift Lever Pivot Clip
Differential Shift Cable Upper End Clip
Differential Shift Lever Mounting Nut
Front Final Gear Case Mounting Nuts (KAF620E/H)
Front Final Gear Case Bracket Bolts (KAF620E/H)
Propeller Shaft Bearing Mounting Nuts (KAF620E/H)
2WD/4WD Shift Lever Pivot Clip (KAF620E/H)
2WD/4WD Shift Lever Mounting Nut (KAF620E/H)
Wheels:
Wheel Nuts
Brakes:
Master Cylinder Mounting Bolts
Master Cylinder Push Rod Clevis Pin Clip
Parking Brake Lever Assembly Mounting Bolts
Parking Brake Cable Lower End Clevis Pin Cotter Pins
Brake Pedal Pivot S haft Cotter Pin
Suspension:
Suspension Arm Pivot B olts
Strut Mounting Nuts
Strut Clamp Nuts and Cotter Pins
Leaf Spring Mounting Nuts
Shock Absorber Mounting Nuts
Page view 364
1 2 ... 360 361 362 363 364 365 366 367 368

Comments to this Manuals

No comments