California Air Tools 3010 Service Manual Page 101

  • Download
  • Add to my manuals
  • Print
  • Page
    / 506
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 100
FUEL SYSTEM 3-31
Fuel Tank
Check that the dampers [A] are in place on the frame and
holder.
15 mm (0.60 in.) [B]
Run the fuel hoses and air vent hose correctly (see Cable,
Wire, and Hose Routing section in the Appendix chapter).
Fuel Tank Cleaning/Inspection
WARNING
Clean the tank in a well-ventilated area, and take
care that there is no spark or flame anywhere near
the working area. Because of the danger of highly
flammable liquids, do not use gasoline or low-flash
point solvents to clean the tank.
Remove the fuel tank and drain it.
Remove the fuel level gauge (see Fuel Level Gauge Re-
moval).
Pour some high-flash point solvent into the fuel tank and
shake the tank to remove dirt and fuel deposits.
Pour the solvent out of the tank.
Dry the tank with compressed air.
Visually inspect the following items for any damage.
Fuel Tank Cap Gasket
Fuel Level Gauge Gasket
Replace the gaskets if they are damaged.
Fuel Level Gauge Removal
WARNING
Fuel is extremely flammable and can be explosive
under certain conditions. Turn the main switch OFF.
Do not smoke. Make sure the area is well-ventilated
and free from any source of flame or sparks; this
includes any appliance with a pilot light.
Page view 100
1 2 ... 96 97 98 99 100 101 102 103 104 105 106 ... 505 506

Comments to this Manuals

No comments