6-22 CONVERTER SYSTEM
Drive Pulley
Bushing Installation
•
Press the cover bushing [A] into the cover [B] using the
special tool so that the end of bushing is flush with the
shoulder [C] in the hole.
Special Tool - Bearin g Driver Set: 570 0 1-1129
•
Press the sheave bushing [A] into the movable sheave [B]
using the special tool so that the end of bushing is flush
with the s houlder [C] in the hole.
Special Tool - Bearin g Driver Set: 570 0 1-1129
Drive Pulley Installation
•
Clean the following portions with an oil-less cleaning fluid
such as trichloroethylene or acetone, and wipe off any oil
with a clean cloth from the tapers.
Fixed Sheave Tapered Portion [A]
Crankshaft Tapered Portion [B]
WARNING
These cleaning fluids are usually highly flammable
and harmful if breathed for prolonged periods. Be
sure to heed the fluid manufacturer’s warnings.
•
Install the drive pulley, and screw in the drive pulley bolt
with the stepped collar [A] and washers [B] as shown in
the figure.
Bolt Head [C]
•
Hold the drive pulley with the drive pulley holder [A].
Special Tool - Drive Pulley Holder: 57001-1548
•
Tighten:
Torque - Drive Pulley Bolt [B]: 93 N·m (9.5 kgf·m, 69 ft·lb)
•
Install the torque converter outer cover (see Torque Con-
verter Outer Cover Installation).
Comments to this Manuals