California Air Tools 3010 Service Manual Page 208

  • Download
  • Add to my manuals
  • Print
  • Page
    / 506
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 207
9-18 CRANKSHAFT/CRANKCASE
Crankshaft and Connecting Rods
Connecting Rod Removal
Remove:
Engine (see Engine Removal in the Engine Removal/In-
stallation chapter)
Cylinder Head (see Cylinder Head Removal in the En-
gine To p End chapter)
Valve Lifters (see Valve Lifter Removal in the Engine Top
End chapter)
Oil Pan (see Oil Pan and Oil Strainer Removal in the
Engine Lubrication System chapter)
Remove the carbon to prevent damaging the piston rings
or piston.
NOTE
Number the connecting rod/piston assemblies before
removing.
Remove:
Connecting Rod Cap Nuts [A]
Connecting Rod C ap [B]
Push the connecting rod end into the cylinder, and pull the
piston and connecting rod out of the cylinder.
Reassemble the connecting rod cap to the connecting rod
to prevent interchanging components.
Connecting Rod Installation
Install the connecting rod bearing inserts.
Be sure tang [A] on the bearing inserts are s eated in the
notches in the connecting rod and cap.
Install a piece of vinyl tubing [B] over each connecting
rod threads to prevent damage to the threads or crankpin
when installing the connecting rod.
Apply engine oil to the following parts.
Cylinder Bores
PistonsandPistonRings
Bearing Inserts and Crankpins
Rotate the crankshaft so that the crankpin is at bottom of
the stroke.
Page view 207
1 2 ... 203 204 205 206 207 208 209 210 211 212 213 ... 505 506

Comments to this Manuals

No comments