California Air Tools 3010 Service Manual Page 180

  • Download
  • Add to my manuals
  • Print
  • Page
    / 506
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 179
7-12 ENGINE LUBRICATION SYSTEM
Oil Pressure Measurement
Oil Pressure Mea surement
Remove the oil pressure sw itch (see Oil Pressure Switch
Removal).
Attach the adapter [A] and gauge [B] to the hole.
Special Tools - Oil Pressure Gauge,10kgf/cm²: 57001-164
Oil Pressure Gauge Adapter, PT 1/8: 57001
-1033
Install the removed parts (see appropriate chapters).
Start the engine and warm up the engine.
Run the engine at the specified speed, and read the oil
pressure gauge.
Oil Pressure
Standard: 196 490 kPa (2.0 5.0 kgf/cm², 28
71 psi) at 3 000 r/min (rp m), oil
temperature 55 65°C (131 149°F)
Stop the engine.
Remove the oil pressure gauge and adapter.
WARNING
Take care against burns from hot engine oil that
will drain through the oil passage when the gauge
adapter is removed.
Install the oil pressure switch (see Oil Pressure Switch
Installation).
Troubleshooting Guide
Low Oil Pressure High Oil Pressure
Engine RPM too low Wrong viscosity oil
Wrong viscosity or diluted oil Plugged oil ga lleries
Low oil level
Broken relief valve spring
Missing relief valve plunger
Worn bearings
Damaged or defective oil pump
Page view 179
1 2 ... 175 176 177 178 179 180 181 182 183 184 185 ... 505 506

Comments to this Manuals

No comments