California Air Tools 3010 Service Manual Page 252

  • Download
  • Add to my manuals
  • Print
  • Page
    / 506
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 251
10-28 TRANSMISSION
2WD/4WD S hift Mechanism
Push the shift shaft [A] as shown in the figure.
Install:
Washer [B]
Shift Shaft Stop Bolt [C]
Tighten:
Torque - Shift Shaft Stop Bolts: 7.8 N·m (0.80 kgf·m, 69
in·lb)
Wipe off any protruding grease.
Install the spring [A].
Turn the shift shaft [B] counterclockwise until it is stop and
hold it.
Install the shift shaft lever [C] on the shift shaft so that the
center of the lever hole with the mark [D] as shown in the
figure.
Tighten the shift shaft l ever mounting nut [E].
Hook the spring end.
Check that each gear and shifter spins or slides freely on
its shaft without binding after assembly.
2WD/4WD Shift Mechanism Inspection
Visually inspect the following parts.
Dogs on Shifter [A]
Shifter Groove [B]
Dogs on Drive Bevel Gear Shaft [C]
Shifter B lock [D]
If they are damaged or worn excessively, replace them.
Replace parts worn beyond the service limit.
Shifter Block Outside Diameter
Standard: 13.95 14.00 mm (0.549 0.551 in.)
Service Limit: 13.8 m m (0.543 in.)
Shifter G roove Width
Standard: 14.0 14.2 mm (0.551 0.559 in.)
Service Limit: 14.3 mm (0.563 in.)
Page view 251
1 2 ... 247 248 249 250 251 252 253 254 255 256 257 ... 505 506

Comments to this Manuals

No comments