California Air Tools 3010 Service Manual Page 307

  • Download
  • Add to my manuals
  • Print
  • Page
    / 506
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 306
FINAL DRIVE 12-37
Drive Shaft and Axles
Check the universal joints.
If any joint does not work smoothly without rattling or stick-
ing, the joint bearing is damaged. Replace the axle.
Visually inspect the splines on the shaft.
If they are badly worn or chipped, replace the axle.
Clean off the joint parts.
CAUTION
Never clean the boots with m ineral oil or gasoline
because they will deteriorate the boot.
Replace the following parts with new ones.
Joint Boots
Circlip
Boot Bands
Install the outboard joint boot [A].
Pack the outboard joint with 40 ±10 g (1.4 ±0.4 oz) of the
special grease.
CAUTION
Be sure to use the special grease in the boot set.
Pour the grease in the outboard boot 1/3 1/2 the capac-
ity of the boot.
Install the outboard boot [A] on the outboard joint and
shaft [B] properly as shown in the figure.
Clamp the boot bands [C] and bend [D] the tangs [E] se-
curely to hold down the end of the band.
Page view 306
1 2 ... 302 303 304 305 306 307 308 309 310 311 312 ... 505 506

Comments to this Manuals

No comments