California Air Tools 3010 Service Manual Page 240

  • Download
  • Add to my manuals
  • Print
  • Page
    / 506
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 239
10-16 TRANSMISSION
Transmissio n and Shift Mechanism
Screw the joint [A] of the shift shaft lever [B] fully into the
transmission shift cable [C] end, and install the cable onto
the bracket [D].
Line up the punch mark [A] on the shift arm, projection
[B] on the transmission case and slit opening in the shift
shaft lever [C].
Tighten:
Shift Shaft Lever Nut [D]
Shift Shaft Lever Clamp Bolt [E]
Hold the shift shaft lever [A] in the neutral position, and
then pull the outer cable [B] lightly forward to remove the
cablefreeplay.
NOTE
If the cable cannot be adjusted, move the slit opening in
the shift shaft lever one notch to right side of the punch
mark on the shift arm.
Tighten:
Transmission Shift Cable Adjuster Nut [C]
Transmission Shift Cable Adjuster Nut [D]
Install the spring [A] back onto the shift shaft lever assem-
bly.
Check the shift lever position (see Shift Lever Position
Inspection).
Page view 239
1 2 ... 235 236 237 238 239 240 241 242 243 244 245 ... 505 506

Comments to this Manuals

No comments