12-38 FINAL DRIVE
Drive Shaft and Axles
•
Install:
Small Boot Band [A]
Inboard Boot [B]
Steel Ball Holder [C]
Steel Ball Base [D]
○
Install the steel ball holder [A] as shown in the figure.
○
Face the chamfered side [B] of the steel ball base [C] to
the boot.
Outboard Shaft [D]
•
Install the circlip [A].
Special Tool - Out side Circlip Pliers: 57 0 01 -144
•
Align the recesses of the steel ball base and holes in the
steel holder, and install the steel balls [A].
•
Pack the inboard joint with 35 ±10 g (1.2 ±0.4 oz) of the
special grease.
○
Pour the special grease in the outboard shaft housing [A]
about 25 g (0.9 oz).
Comments to this Manuals