California Air Tools 3010 Service Manual Page 416

  • Download
  • Add to my manuals
  • Print
  • Page
    / 506
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 415
16-16 FRAME
Front, Center and Rear Bars
Remove the air duct [A].
Remove:
Rear Bar Mounting Bolts and Nuts [A]
Rear Bar [B]
Slide back the rear bar and remove it from the vehicle.
Rear Bar Installation
Be sure the rubber plates [A] are in position.
Plug one hole [B] and plug only half about another hole
[C], using the rubber plate.
Tighten:
Torque - Rear Bar Mounting Bolts: 44 N·m (4.5 kgf·m, 32
ft·lb)
CargoBedLatchPositionInspection
Cargo bed must be latched securely on the cargo bed
hooks [A] without rattling.
Latch [B]
If there is rattling or not snug enough, adjust the latch
positions.
Cargo Bed Latch Position Adjustment
Release the mounting bolts [A].
Reposition the latch to the suitable place by sliding within
the ellipse bolt holes.
Retighten the mounting bolts.
NOTE
Adjustment must be made on both sides.
Page view 415
1 2 ... 411 412 413 414 415 416 417 418 419 420 421 ... 505 506

Comments to this Manuals

No comments