17-28 ELECTRICAL SYSTEM
Alternator
•
Remove:
Bearing Holder [A]
Ball Bearing [B]
○
To remove the ball bearing [A], use a suitable puller.
Alternator Assembly
•
Press the bearing and bearing holder onto the rotor shaft.
•
Straighten the stator coil wires.
•
Install:
Housing Cover [A]
Housing Cover Mounting Bolts [B] and Nuts [C]
•
Install the rectifier [A].
•
Bend the stator coil wire ends [B] around the screw holes.
•
Tighten the rectifier screws.
•
Install:
Regulator
Brush Holder
End Cover
Insulator
Terminal Nut
Comments to this Manuals