California Air Tools 3010 Service Manual Page 309

  • Download
  • Add to my manuals
  • Print
  • Page
    / 506
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 308
FINAL DRIVE 12-39
Drive Shaft and Axles
Install the retaining ring [A] so that the opening [B] is
aligned with one of the projections [C].
Install the inboard boot [A] on the outboard joint and shaft
[B] properly as shown in the figure.
119 m m (4.69 in.) [C]
Clamp the small boot band [D] and bend the tang securely
to hold down the end of the band.
Slightly open [A] the larger diameter end of the joint boot
to equalize the air pressure inside the boot.
Clamp the large boot band [A] and bend the tang securely
to hold down the end of the band.
Ball Bearing I nspection
Since the ball bearings are made to extremely c lose toler-
ances, the wear must be judged by feel rather than mea-
surement. Clean each bearing in a high-flash point sol-
vent, dry it (do not spin the bearing while it is dry), and oil
it with engine oil.
Spin [A] the bearing by hand to check its condition.
If the bearing [B] is noisy, does not spin smoothly, or has
any rough spots, replace it.
Page view 308
1 2 ... 304 305 306 307 308 309 310 311 312 313 314 ... 505 506

Comments to this Manuals

No comments