California Air Tools 3010 Service Manual Page 332

  • Download
  • Add to my manuals
  • Print
  • Page
    / 506
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 331
13-22 BRAKES
Brake Panel Assemblies
Grease Seal Replacement
Remove:
Brake Panel Assy (see Brake Panel Assy Removal)
Grease Seal [A]
CAUTION
Be careful not to damage the brake panel when re-
moving the grease seal.
Install the grease seal [A] to specified position as shown
in the figure.
Top Surface of Grease Seal [B]
Center Bottom of Brake Panel [C]
11.2 12.0 mm (0.44 0.47 in.) [D]
NOTE
If the following special tool (Grease Seal Driver Set) is
used, the position will be secured.
Apply soapsuds to inside area of the new grease s eal.
Put the brake panel on a suitable flat plate [A] so that the
bleed valve fitting [B], boss [C] and parking brake lever
linkage [D] (rear only) are not contact to the plate.
Put the guide [E] in the panel so that the UP mark [F] faces
upward.
Special Tool - Grease Seal Driver Set: 57001-1629
Put the grease seal [G] on the brake panel evenly.
Put the grease seal driver [A] on the grease seal evenly.
Special Tool - Grease Seal Driver Set: 57001-1629
Put the compressor [B] to center on the grease seal driver.
Special Tool - Clutch Spring Compressor: 57001-1162
Using a press install the grease seal.
Apply high-temperature grease (Amoco Rykon Premium
Grease No. 2 EP Green) to the grease seal lips (see
Brake Drum Installation).
Page view 331
1 2 ... 327 328 329 330 331 332 333 334 335 336 337 ... 505 506

Comments to this Manuals

No comments