California Air Tools 3010 Service Manual Page 460

  • Download
  • Add to my manuals
  • Print
  • Page
    / 506
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 459
17-40 ELECTRICAL SYSTEM
Preheating System
Glow Plug Removal
Tilt up the cargo bed.
Remove the caps [A].
Remove:
Connecting Plate Nuts [A]
Connecting Plate [B]
Glow Plug Lead [C]
Remove the glow plug [A].
Glow Plug Installation
Tighten:
Torque - Glow Plugs: 17 N·m (1.7 kgf·m, 13 ft·lb)
Connecting Plate Nuts: 1.2 N·m (0.12 kgf·m, 11
in·lb)
Glow Plug Inspection
Using the × 1 range of the hand tester, measure the
resistance between the terminal [A] and the housing [B]
of the glow plug.
Special Tool - Hand Tester: 57001-1394
If the tester does not read as specified, replace the glow
plug.
Glow Plug Resistance: About 0.1 5.0
NOTE
Be careful not to apply the battery voltage to the glow
plug directly.
Be careful not to scratch the heater section [C].
Page view 459
1 2 ... 455 456 457 458 459 460 461 462 463 464 465 ... 505 506

Comments to this Manuals

No comments