California Air Tools 3010 Service Manual Page 354

  • Download
  • Add to my manuals
  • Print
  • Page
    / 506
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 353
15-6 STEERING
Steering W heel and Main Shaft Assembly
Steering Wheel Position Adjustment
Loosen the steering shaft mounting nuts [A].
Adjust the s teering wheel position.
Tighten the main shaft bracket mounting nuts securely.
Steering Wheel Free Play Inspection
Refer to the Steering Inspection in the Periodic Mainte-
nance chapter.
Steering Wheel Centering
Test ride the vehicle.
If the steering wheel is not straight when the vehicle is
traveling in a straight line, do the following.
Check the tie-rod length and adjust it if necessary.
Remove the wheel cap and horn switch (see Steering
Wheel and Steering Shaft R emoval).
Loosen the steering wheel mounting nut [A].
Push the vehicle in a straight line with no one aboard, and
stop it without turning the steering wheel.
Remount the steering wheel so that it is straight ahead.
Install the spring washer and tighten the mounting nut.
Torque - Steering W heel Mounting Nut: 52 N ·m (5.3 kgf·m,
38 ft·lb)
Install the horn switch and wheel cap (see Steering Wheel
and Steering Shaft Installation).
Be sure to register the EPS neutral position (see EPS
Neutral Position Registration).
Steering Wheel and Steering Shaft Removal
Remove the wheel cap [A].
Pry the wheel cap with a thin driver [B].
Page view 353
1 2 ... 349 350 351 352 353 354 355 356 357 358 359 ... 505 506

Comments to this Manuals

No comments