California Air Tools 3010 Service Manual Page 397

  • Download
  • Add to my manuals
  • Print
  • Page
    / 506
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 396
STEERING 15-49
EPS (Electric Power Steering) System
Install the upper universal joint [A] to the shaft of the EPS
unit [B].
Install the universal joint clamp bolt (lower) [C] while align-
ing the notch on the shaft of the EPS unit with the clamp
bolt hole on the upper universal joint, and tighten it tem-
porary.
Install the steering shaft [D] to the upper universal joint.
Install the universal joint clamp bolt (upper) [E] while align-
ing the notch on the steering shaft with the clamp bolt hole
on the upper universal joint, and tighten it temporary.
Install the steering shaft mounting bolts [F], washers [G]
and nuts [H].
Tighten all the universal joint clamp bolts to the specified
torque.
Torque - Universal Joint Clamp Bolts: 20 N·m (2.0 kgf·m,
15 ft·lb)
Mount the steering wheel on the steering shaft temporar-
ily.
Adjust the following items.
Steering Wheel Position (see Steering Wheel Position
Adjustment)
Steering Wheel Centering (see Steering Wheel Center-
ing)
Install the removed parts (see appropriate chapters).
Be sure to register the EPS neutral position (see EPS
Neutral Position Registration).
Speed Sensor Remo val/Installation
Refer to the Speed Sensor Removal/Installation in the
Electrical System chapter.
Speed Sensor Inspec tion
Refer to the Speed Sensor Inspection in the Electrical
System chapter.
If the speed sensor is normal, check the wiring for conti-
nuity (Refer to the next wiring diagram.).
Page view 396
1 2 ... 392 393 394 395 396 397 398 399 400 401 402 ... 505 506

Comments to this Manuals

No comments