California Air Tools 3010 Service Manual download pdf (Page 319)

100

101

BRAKES 13-9

Brake Fluid

•

Remove the wheel for extra clearance (see Wheel Re-

moval in the Wheels/Tires chapter).

•

Connect a clear plastic hose [A] to the bleed valve at the

wheel cylinder, and run the other end of the hose into a

container.

Brake Panel [B]

NOTE

○

Start with the rear left or right wheel and finish with the

front left or right wheel.

•

Bleed the brake line and the caliper as follows.

○

Repeat this operation until no more air can be seen com-

ing out into the plastic hose.

1. Pump the brake pedal [A] until it becomes hard, and

apply the brake pedal and hold it.

2. Quickly open and close the bleed valve while holding the

brake pedal applied.

3. Release the brake pedal.

•

Tighten:

Torque - Bleed Valves: 5.4 N·m (0.55 kgf·m, 48 in·lb)

•

Repeat the previous step for each wheel.

•

When air bleeding is finished, add fluid up to the upper

level in the reservoir.

•

Apply the brake forcefully for a few seconds, and check

for fluid leakage around the fittings.

•

Install the removed parts (see appropriate chapters).

Torque - Master Cylinder Reservoir Cap: 3.4 N·m (0.35

kgf·m, 30 in·lb)

1 2 ... 314 315 316 317 318 319 320 321 322 323 324 ... 505 506

Comments to this Manuals

No comments

California Air Tools 3010 Service Manual Page 319

Comments to this Manuals

Related products and manuals for Air compressors California Air Tools 3010