California Air Tools 3010 Service Manual Page 478

  • Download
  • Add to my manuals
  • Print
  • Page
    / 506
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 477
17-58 ELECTRICAL SYSTEM
Fuses
Fuse Removal
Tilt up the seat.
Unlock the hook to lift up the lid [A].
Fuse Location [B]
Fuses [C]
Fuse Remover [D]
50 A Fuse [E]
Pull the fuse [A] straight out of the fuse box with the fuse
remover [B].
Unlock the stopper [A] and pull the 50 A fuse [B] straight
out of the fuse box.
Fuse Installation
If a fuse fails during operation, inspect the electrical sys-
tem to determine the cause, and then replace it with a
new fuse of proper amperage.
Install the fuse box fuses on the original position as spec-
ifiedonthelid.
Fuse Inspection
Remove the fuse (see Fuse Removal).
Inspect the fuse element.
For 50 A fuse, there is window for inspection in the upper
surface.
If it is blown out, replace the fuse. Before replacing a
blown fuse, always check the amperage in the affected
circuit. If the amperage is equal to or greater than the
fuse rating, check the wiring and related components for
a short circuit.
Housing [A] Te rminals [C]
Fuse Element [B] Blown Element [D]
CAUTION
When replacing a fuse, be sure the new fuse
matches the specified fuse rating for that circuit.
Installation of a fuse with a higher rating may cause
damage to wiring and components.
Page view 477
1 2 ... 473 474 475 476 477 478 479 480 481 482 483 ... 505 506

Comments to this Manuals

No comments