California Air Tools 3010 Service Manual download pdf (Page 300)

100

101

12-30 FINAL DRIVE

Propeller Shafts

Propeller Shaft Installation

•

Wipe the old grease off the splines of the propeller shafts,

and grease to them.

•

Inspect the propeller shafts (see Propeller Shaft Inspec-

tion).

•

Apply grease to the O-ring [A] on the front pinion gear.

•

Install the front propeller shaft yoke [B] on the pinion gear.

•

Put the propeller shaft bearing housing [C] at fully outside

position.

•

Install the rear propeller shaft yoke [D] on the rear driven

gear shaft so that the thin side [E] of the propeller shaft

positions to the rearward.

•

Install the rear propeller shaft yoke [F] on the front pro-

peller shaft rear end [G], aligning the yoke angles [H] of

the front and rear propeller shafts.

•

Parallel [I] the propeller shaft bearing housing [J] with the

mounting bracket [K].

○

Make the 3 mm (0.12 in.) clearance [L] between the yoke

[B] of the front propeller shaft and the front pinion gear nut

[M].

•

Install:

Propeller Shaft Bearing Housing Bolts [N]

Washers [O]

Collars [P]

Nuts [Q]

1 2 ... 295 296 297 298 299 300 301 302 303 304 305 ... 505 506

Comments to this Manuals

No comments

California Air Tools 3010 Service Manual Page 300

Comments to this Manuals

Related products and manuals for Air compressors California Air Tools 3010